9/21/2023 0 Comments Victron battery monitor manualSome Li-ion chargers stop charging when the charge current drops below a set level - the Tail current value may need to be increased so that the full State of Charge is detected. The default Charged Voltage is often suitable for the most common Li-ion batteries (LiFePo4 type). You can also set the Relay minimum enable time and Relay disable delay to control how long the generator is allowed to run. The Clear SOC relay determines the high State of Charge (default 90%) when the generator is switched off. The Discharge Floor sets the low State of Charge (default 50%) when the generator switches on. The BMV has an 'alarm relay' which can be used to switch a back-up generator. The standard settings are shown in the table below, you can change these values to change how your BMV behaves. The default settings are suitable for a standard lead-acid battery bank. Configure the rest of the settings if required You can also sync manually: hold the (+) and (-) keys simultaneously for 3 seconds to set State of Charge to 100%.ģ. The State of Charge needs to be calibrated - t his happens automatically when the battery reaches a full state of charge. Press the Setup key again for 2 seconds and the display goes back to normal operation Press the Setup key for 2 seconds to lock your setting Use the Select key and (+) and (-) keys to set the Ah value Press the Setup key for 2 seconds - the display shows 'Cb 0200Ah' ("C20" means the Ah capacity when the battery is discharged over 20 hours) The battery voltage is automatically detected. The installer must program in the "C20" Ah capacity of the battery bank.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |